IKE SA: created 1/1 established 1/1 time 10/10/10 ms MSCHAP-v2 peer authentication failed for remote host : LCP Termiate_Request id(5) len(25) SND: CHAP Failure id(1) msg(Authentication Fail!O1) If PAP is not explicitly set under client adaptor setting, the connection would fail with below error in L2TP debugs on FortiGate: Go to adaptor Properties - > Security and select PAP as below: So its very important to set this under VPN adaptor properties to be able to connect to VPN successfully. Set uuid ac305d9e-f7e1-51ec-7867-47660df85033Įdit 2 Settings - > Network & Internet - > VPN - > Add a VPN connection.Ģ) Due to point to point protocol limitation, only PAP is supported for ldap authentication for l2tp. Set psksecret ENC hb3pmKyut/c3zGiYuQJAIXb9BP27QzrDsaKc10C+sNFevSgdbgKLkV+YT+bj12ailMFdzXcolWO06jlhdNlwNxcgi7Yj0zzHLvb36b20QcxBsr6JJMy/fBbzWgxkKPYfngiuNA1bvgwj9aMREz0FVJ7yOoSDIdFZmhShHMc+PdKt4A91nFFDgkh7BTvIh5qw+Bl+qA=Ĥ) In FortiOS 7.0, two policies would be required :Įdit 1 -> This will be used for L2TP tunnel setup Set comments "VPN: ipsec-l2tp (Created by VPN wizard)" Set proposal aes256-md5 3des-sha1 aes192-sha1
Set the authentication method as 'Pre-shared key' and select AD user group.
This article describes the settings required on FortiGate and Windows 10 client in order to successfully connect to L2TP over IPSec VPN with LDAP authentication and access resources behind FortiGate.ġ) Setup LDAP profile under User & Authentication - > LDAP server:Ģ) Create a user group corresponding to AD group under User & Authentication - > User groups:ģ) Create VPN by using the wizard and make use of 'remote access' and 'native windows' template.
0 kommentar(er)
